An all aluminum alloy stock for the Benjamin Trail NP air pistol. Fits both
mark 1 and mark 2.
ZERO Plastics/3D printing is used. The superiority of aluminum over 3D
printing in terms of robustness isby far greater than 30x. Where plastics
break, aluminum lasts.
The stock is installed via its aluminum connector piece that fully replaces
the original plastic end cap. Remove the old end cap by driving out the pin and
removing the bottom screw. Install the connector by pushing until the bottom
screw can be inserted by hand, then align the pin holes.
The length of the stock is 21-29cm, in 3 stages starting from the
installation point.
This item fully complies with Ebay's firearm/air gun/accessories policy. The
stock has been designed and built to fit the Benjamin Trail NP air pistol only,
it canNOT be modified into a firearm part without destroying the item! This
item does NOT alter/enhance the mechanical function of the air pistol!